Gardman 250 LED String Lights - Manual (Page 2)

n The batteries (1 x AA) can be replaced with any 1.2v
rechargeable ones available in retail outlets: choose
a low power output (mAh). Gardman replacement
batteries are ideal for the purpose.
n Low winter light levels or harsh weather in your locality
may lead you to decide to store your solar lights indoors
until conditions improve. If so, clean and dry the lights,
turn off or remove the batteries: store in a dry spot
and reassemble in spring as described in ‘installation’.
Troubleshooting:
If your solar light does not operate properly at night it may
be caused by one of the following:
n Ensure the switch, if present, is in the on position and
any battery tabs removed.
n Low light levels caused by the position of the solar
panel, lack of sunlight or short daylight hours will
reduce the light duration.
n Other lighting can cause flickering in a solar light or
even prevent it operating.
n Check that there are no breaks in the wiring and that
the connections are secure.
n Check the batteries in case they need replacing: see
‘maintenance’ above.
In the event of your Solar Light failing, please turn the
operating switch off and leave to fully charge for 2 - 3
days in direct sunlight. After this time turn the switch
back to the ‘on’ position for working operation. If the
operation failure continues to persist, please contact
our Customer Service department.
Assembly:
n Remove the parts carefully from to avoid tangling the wires.
n Connect the string lights into the solar panel by pushing the
connector into the corresponding hole in the panel.
n Connect the solar panel to the spike.
n Ensure the switch is in the on position.
Installation:
n It is important to position the solar panel where it will receive
maximum sunlight. The position needs to be where it is free
from cover or shade and, ideally, in a position that receives
full sun throughout the day.
n Avoid other light sources which may cause solar lights
to flicker on and off. Also allow a space of approx. 1.5m (5ft)
between this and other solar lights.
n Lay out the lights where they are intended to be sited:
good sites are in amongst foliage and trellis or twined around
garden features. Adjust as necessary until the lights and the
panel are in the desired positions.
n Secure the lights carefully so that they cannot be easily
dislodged and damaged.
n Insert the solar panel spike in the ground or otherwise
make it secure, ensuring that it is angled towards the sun.
n Solar lights will not be very bright or long lasting until a full
day’s sunlight has been received. Alternatively, batteries can
be charged to full capacity in a battery charger before use.
Maintenance:
n If solar panels get dirty, the charging capacity will be
reduced. Clean panels occasionally with a damp cloth – avoid
harsh detergents or solvents as these can damage the panel.
n Batteries can be given a temporary boost in a battery
charger if there has been limited sun or extra light is
needed for a special occasion.
n Batteries may need replacing after 1-2 years, depending
on the conditions they have had to endure. The batteries
are housed on the underside of the solar panel and can be
easily accessed by unscrewing the 4 screws.
3 2