Gardman 3 Sparkling Bubble Lights - Manual (Page 2)

Assembly:
n remove the parts carefully from the packaging to avoid
tangling the wires.
n insert the lights wire into the connector on the solar
panel and insert the spikes into the bubble stems.
n the on/off switch is located on the underside of the solar
panel and should be switched to ‘on’ to activate the light.
Installation:
n it is important to position the solar panel where it will
receive maximum sunlight. the position needs to be
where it is free from cover or shade and, ideally, in a
position that receives full sun throughout the day.
n Avoid other light sources which may cause solar lights
to flicker on and off. Also allow a space of approx. 1.5m
(5ft) between this and other solar lights.
n lay out the lights on the ground where they are intended
to be sited and adjust as necessary until the lights and
the panel are in the desired positions.
n Push the lights carefully into the ground: if the ground is
hard, first make a hole so that the light is not damaged
by rough handling. Do the same with the solar panel,
making sure that it is facing upwards towards the sun.
n Solar lights will not be very bright or long lasting until a
full day’s sunlight has been received. Alternatively,
batteries can be charged to full capacity in a battery
charger before use.
Maintenance:
n if solar panels get dirty, the charging capacity will be
reduced. Clean panels occasionally with a damp cloth –
avoid harsh detergents or solvents as these can damage
the panel.
n Batteries can be given a temporary boost in a battery
charger if there has been limited sun or extra light is
needed for a special occasion.
n Batteries may need replacing after 1-2 years, depending
on the conditions they have had to endure. the
batteries are housed under the solar panel and can be
easily accessed by removing the sliding cover.
n the battery (1 x AA) can be replaced with any 1.2v
rechargeable ones available in retail outlets: choose
a low power output (mAh). gardman replacement
batteries are ideal for the purpose.
n low winter light levels or harsh weather in your locality
may lead you to decide to store your solar lights indoors
until conditions improve. if so, clean and dry the lights,
turn off or remove the batteries: store in a dry spot
and reassemble in spring as described in ‘installation’.
Troubleshooting:
if your solar light does not operate properly at night it may
be caused by one of the following:
n ensure the switch, if present, is in the on position and
any battery tabs removed.
n low light levels caused by the position of the solar
panel, lack of sunlight or short daylight hours will
reduce the light duration.
n Other lighting can cause flickering in a solar light or
even prevent it operating.
n Check that there are no breaks in the wiring and that
the connections are secure.
n Check the batteries in case they need replacing: see
‘maintenance’ above.