Gardman 2 Carriage Post Lights - Manual (Page 2)

n Batteries may need replacing after 1-2 years, depending
on the conditions they have had to endure. The
batteries are housed in the back of the solar panel and
can be easily accessed by removing the panel and the
battery cover.
n The batteries (1 x AA per light) can be replaced with any
1.2v rechargeable ones available in retail outlets: choose
a low power output (mAh). Gardman replacement
batteries are ideal for the purpose.
n Low winter light levels or harsh weather in your locality
may lead you to decide to store your solar lights indoors
until conditions improve. If so, clean and dry the lights,
turn off or remove the batteries: store in a dry spot
and reassemble in spring as described in ‘installation’.
Troubleshooting:
If your solar light does not operate properly at night it may
be caused by one of the following:
n Ensure the switch, if present, is in the on position and
any battery tabs removed.
n Low light levels caused by the position of the light, lack
of sun or short daylight hours will shorten the
light duration.
n Other lighting can cause flickering in a solar light or
even prevent it operating.
n Check the batteries in case they need replacing: see
‘maintenance’ above.
Assembly:
n Carefully remove the parts from the packaging.
n Remove the battery tab to activate. The battery tab can
be accessed by twisting the plastic head anticlockwise
to reveal the battery tab.
n Reattach the plastic head onto the light assembly.
n Push the solar panel onto the stem and then push the
spike into the bottom of the stem.
Installation:
n Maximum sunlight will give the internal battery
the best charge and so give best results.
n Position solar lights where they are free from cover or
shade and, ideally, in a position that receives full sun
throughout the day.
n Avoid other light sources which may cause solar lights
to flicker on and off. Also allow a space of approx. 1.5m
(5ft) between solar lights.
n Push the stem section carefully into the ground: if the
ground is hard, first make a hole to avoid damaging it.
n Solar lights will not be very bright or long lasting until
a full day’s sunlight has been received.
n Alternatively, batteries can be charged to full capacity in
a battery charger before use.
Maintenance:
n If solar panels get dirty, the charging capacity will be
reduced. Clean panels occasionally with a damp cloth
– avoid harsh detergents or solvents as these can
damage the panel.
n Batteries can be given a temporary boost in a battery
charger if there has been limited sun or extra l ight is
needed for a special occasion.