beautypg.com

Gardman 50 LED String Lights Exstra Large Bulb User Manual

Page 2

background image

n

Batteries can be given a temporary boost in a battery

charger if there has been limited sun or extra light is
needed for a special occasion.

n

Batteries may need replacing after 1-2 years, depending

on the conditions they have had to endure. The
batteries are housed under the solar panel and can be
easily accessed by removing the cover.

n

The batteries (1 x AA) can be replaced with any 1.2v

rechargeable ones available in retail outlets: choose
a low power output (mAh). Gardman replacement
batteries are ideal for the purpose.

n

Low winter light levels or harsh weather in your locality

may lead you to decide to store your solar lights indoors
until conditions improve. If so, clean and dry the lights,
turn off or remove the batteries: store in a dry spot
and reassemble in spring as described in ‘installation’.

Troubleshooting:

If your solar light does not operate properly at night it may
be caused by one of the following:

n

Ensure the switch, if present, is in the on position and

any battery tabs removed.

n

Low light levels caused by the position of the solar

panel, lack of sunlight or short daylight hours will
reduce the light duration.

n

Other lighting can cause flickering in a solar light or

even prevent it operating.

n

Check that there are no breaks in the wiring and that

the connections are secure.

n

Check the batteries in case they need replacing: see

‘maintenance’ above.

Assembly:

n

Remove the parts carefully from to avoid tangling the wires.

n

Connect the string lights into the solar panel by pushing the

connector into the corresponding hole in the panel.

n

Connect the solar panel to the spike.

n

Ensure the switch is in the on position.

Installation:

n

It is important to position the solar panel where it will receive

maximum sunlight. The position needs to be where it is free
from cover or shade and, ideally, in a position that receives
full sun throughout the day.

n

Avoid other light sources which may cause solar lights

to flicker on and off. Also allow a space of approx. 1.5m (5ft)
between this and other solar lights.

n

Lay out the lights where they are intended to be sited:

good sites are in amongst foliage and trellis or twined around
garden features. Adjust as necessary until the lights and the
panel are in the desired positions.

n

Secure the lights carefully so that they cannot be easily

dislodged and damaged.

n

Insert the solar panel spike in the ground or otherwise

make it secure, ensuring that it is angled towards the sun.

n

Solar lights will not be very bright or long lasting until a full

day’s sunlight has been received. Alternatively, batteries can
be charged to full capacity in a battery charger before use.

Maintenance:

n

If solar panels get dirty, the charging capacity will be

reduced. Clean panels occasionally with a damp cloth – avoid
harsh detergents or solvents as these can damage the panel.