beautypg.com

Gardman Flickering Bronze Candle Lantern 1 User Manual

Page 2

background image

Assembly:

n

Remove the parts carefully from the packaging.

n

Move the switch on the underside of the top section to ‘on’.

Installation:

n

Maximum sunlight will give the internal battery

the best charge and so give best results.

n

Position solar lights where they are free from cover or

shade and, ideally, in a position that receives full sun
throughout the day.

n

Avoid other light sources which may cause solar lights

to flicker on and off. Also allow a space of approx. 1.5m
(5ft) between solar lights.

n

The light is perfect for table-top use but can be stood on

any flat surface.

n

Solar lights will not be very bright or long lasting until

a full day’s sunlight has been received.

n

Alternatively, batteries can be charged to full capacity in a

battery charger before use.

Maintenance:

n

If solar panels get dirty, the charging capacity will be

reduced. Clean panels occasionally with a damp cloth
– avoid harsh detergents or solvents as these can damage
the panel.

n

Batteries can be given a temporary boost in a battery

charger if there has been limited sun or extra light is
needed for a special occasion.

n

Batteries may need replacing after 1-2 years, depending

on the conditions they have had to endure.
The batteries are housed on the reverse of the solar
panel and can be accessed by removing the panel.

n

The batteries (2 x AA per light) can be replaced with any

1.2v rechargeable ones available in retail outlets: choose
a low power output (mAh). Gardman replacement
batteries are ideal for the purpose.

n

Low winter light levels or harsh weather in your locality

may lead you to decide to store your solar lights indoors
until conditions improve. If so, clean and dry the lights,
turn off or remove the batteries: store in a dry spot
and reassemble in spring as described in ‘installation’.

Troubleshooting:

If your solar light does not operate properly at night it may
be caused by one of the following:

n

Ensure the switch, if present, is in the on position and

any battery tabs removed.

n

Low light levels caused by the position of the light, lack

of sun or short daylight hours will shorten the
light duration.

n

Other lighting can cause flickering in a solar light or

even prevent it operating.

n

Check the batteries in case they need replacing: see

‘maintenance’ above.