Blaupunkt LOS ANGELES MP71 - Manual (Page 14)

14
Setting the station
There are a number of ways to set the sta-
tion.
Automatic station search
➮
Press the or button
7
.
The next station that can be received is tuned
in.
Manual station tuning
You can also tune to the station manually:
➮
Press the or button
7
.
Setting station search sensitivity
You can choose whether to search only for
stations with strong signals, or whether weak
stations should be included:
➮
Select the waveband (AM or FM) to
which the setting should apply.
➮
Press the MENU button,
8
.
➮
Press the or button
7
until “FM-
SENS” or “AM-SENS” appears in the
display.
➮
Press the button or
7
.
The current sensitivity value is shown on the
display. “SENS 6” indicates the maximum
sensitivity for the reception of distant trans-
mitters, and “SENS 1” indicates the lowest
sensitivity.
➮
Set the desired sensitivity by pressing
or
7
.
➮
Press the OK button
5
or the MENU
button
8
to leave the menu. The set-
tings are then saved.
Saving a station
Saving a station manually
➮
Choose the desired memory level: FM I,
FM II, FMT, M or MT.
➮
Tune in the desired station as described
under “Setting the station”.
➮
Hold down the softkey
4
indicating the
position [(“ST1” - “ST6”) where the sta-
tion is to be stored] for longer than two
seconds.
Saving a station automatically
(Travelstore)
You can also save the six strongest stations
in the area automatically. This is done in the
FMT and MT memory levels.
Note:
Any stations previously saved on this level will
be deleted.
To use the Travelstore function:
➮
Press the TUNE button
>
when the ra-
dio is operating.
The radio function menu is shown on the dis-
play.
➮
Press the softkey
4
indicating “TS”.
Storing starts. “T-STORE” appears in the dis-
play. When the procedure is complete, the
station in memory location 1 on the FMT or
MT level is played.
Going to a pre-set station
➮
Select the memory level or waveband.
➮
Press the softkey
4
indicating “ST1” -
“ST6” for the desired station.
RADIO OPERATION