Eschenbach Optik Quicklook Zoom - Manual (Page 16)

16
Note about Auto-off and persistence
By default the Auto-off is enabled, i.e. the
unit will turn itself off after 5 minutes of
non-use. If you disable this function, you
could run the risk that a stationary image
may persist on the display if a unit is left for
a considerable time looking at the same
image. This persistence will clear eventually
but placing the unit on a clean white sheet
of paper and leaving the unit switched on
can help in severe cases.
Reset
If Quicklook stops responding to button
presses it may need to be reset. Using a
pen or similar instrument, press the reset
button recessed into the underside of the
unit near the camera.
Fitting the wrist strap
Quicklook Zoom is supplied with an optional
wrist strap. To fit this, pass the thin loop of
the strap through the hoop on the top of the
unit. Pass the entire strap through the thin
loop and pull tight.