ECOXGEAR IR2500: Innovator III - Manual (Page 13)

13
Back Panel connections
There are two connections on the back panel.
1) The jack for the power adapter. Please plug the supplied power adapter into the radio’s power
adapter jack then plug the other 2 prong end into the wall.
2) Stereo headset jack connection. The headset jack connection can be used to listen to music
in private via your personal headset/headphones (not provided). Alternatively, you can
connect the headset jack to a stereo system’s audio input jacks via the provided cables. If the
cables provided do not work with your type of connection(s) on your stereo system please
contact your local electronics store to purchase the correct connector.
Steps for Connecting Your Radio to Your Wireless
Network
Getting Started
Step 1 - Power up the radio - 1
st
time set up
Connect one end of the AC Power cord to the back of your INNOVATOR III and the other end to the
available wall plug. The radio can be switched on or off with the STANDBY/ON button. The
STANDBY/On button is marked on your radio with this symbol
. If only the clock is displayed on the
top of the display, the unit is in standby mode. Please turn the radio on before going to the next step.
CAUTION: Use only the power adapter supplied with INNOVATOR III. Connecting a power supply with
a different rating will cause permanent damage to INNOVATOR III and may be hazardous and will void
the warranty.
After you turn the radio on it will briefly display the following:
Grace Digital Radio