Dakota Ultrasonics UMX - Manual (Page 4)

4
2. Inspect o-rings for foreign material (sand, seaweed, hair, etc.), cracks, cuts,
soft spots, or deformities. Replace o-ring if damaged. Inspect mating
surfaces for scratches, rough spots, dents, or cracks.
3. Apply thin, even coat of silicone grease to o-rings using fingers. Install
o-ring on the door, place the door on the housing, and close the latches
simultaneously. Inspect for an unbroken dark line on mating surfaces
around centerline of the o-ring, indicating that a proper seal has been made.
WARRANTY
1. The manufacturer inspects and tests each housing for watertight integrity
before it is delivered.
2. The manufacturer will repair or replace at the manufacturer's option any
housing that proves to be defective in construction or materials within one
year of date of delivery.
3. The manufacturer is not liable for damage to equipment caused by
leakage of water into the housing, nor is the manufacturer liable for loss
of data or income therefrom as may result from such leakage. The
manufacturer is not liable for any accidents during which this housing was
in use.
4. This warranty is void in event of negligent handling of the housing
including, but not limited to, dropping the housing, modifications to the
housing by other than the manufacturer, improper care of the sealing
components, and exceeding the specified depth limitation of 300 feet.
5. There is no express or implied warranty, nor warranty of merchantability,
except as stated by the manufacturer above.
6. The buyer understands that, because of the nature of this product, he/she
uses the housing at his/her own risk and agrees to hold the manufacturer
harmless, except as stated above.