Braun SI 3240 - Manual (Page 8)

Removing the steam regulator with the
anticalc valve
Turn the steam regulator clockwise to the
double arrow at the end of the anticalc
section and it will lift. Pull it out vertically.
Do not touch the anticalc valve at its lower
end. Immerse the anticalc valve in vinegar
(not vinegar essence) or lemon juice for
minimum 30 minutes. Brush off remaining
residues and rinse under running water
(fig. F 1-5).
Re-inserting the steam regulator
To re-insert the steam regulator follow fig.
6 and 7.
Notice: The iron must not be used without
the steam regulator.
G Decalcifying/anticalc system
In order to clean the steam chamber from
residues, decalcify it as shown in fig.
G 1-11.
Caution: Hot water and steam will come
out from the sole plate when the steam
regulator is turned clockwise into the anticalc
area.
Wait for the sole plate to cool down, then
clean it as described above.
Then refill the tank with water, heat up the
iron and press the power shot button 4 times
to rinse the iron before ironing (G 12-13).
Do not use commercial decalcifiers, they
may damage the iron.
H Trouble-shooting guide
Subject to change without notice.
This product conforms to the European
Directives EMC 89/336/EEC and Low
Voltage 73/23/EEC.
Guarantee
We grant 1 year guarantee on the product
commencing on the date of purchase. Within
the guarantee period we will eliminate, free of
charge, any defects in the appliance resulting
from faults in materials or workmanship, either
by repairing or replacing the complete appliance
as we may choose.
This guarantee extends to every country where
this appliance is supplied by Braun or its
appointed distributor.
This guarantee does not cover: damage due to
improper use, normal wear or use as well as
defects that have a negligible effect on the value
or operation of the appliance. The guarantee
becomes void if repairs are undertaken by
unauthorised persons and if original Braun parts
are not used.
To obtain service within the guarantee period,
hand in or send the complete appliance with
your sales receipt to an authorised Braun
Customer Service Centre.
Problem Remedy
Drops coming
out of the steam
vents Turn the steam
regulator counter-
clock-wise to reduce
the steam or turn it off.
Take longer intervals
when pressing the
steam plus button.
Less steam
develops or no
steam at all Check water level.
Clean the anticalc
valve.
Calcium particles
coming through
the steam vents Decalcify the steam
chamber.
4671354_SI3000_Korea Seite 8 Mittwoch, 6. Dezember 2006 1:28 13