Bissell PowerSteamer 1693 series - Manual (Page 10)

Reduced Spray Or No Spray.
Possible Causes Remedies
Bladder may be empty Turn power OFF, refill tank with
hot tap water.
The lint screen may be clogged Turn power OFF, clean out lint
screen, follow step 2 on page 6.
Tank-in-Tank may not be seated properly Turn power OFF; remove and
reseat tank
Pump may have lost prime Turn power OFF; after 1 minute, turn
ON and depress Spray trigger.
The Pump Belt may be broken See page 9 for directions on
replacing Belt.
PowerSteamer is not picking up solution.
Possible Causes Remedies
Nozzle Window may not be properly attached Make sure the two tabs on the back
of the Floor Nozzle Window are
inserted through the mating slots in
the main housing. Reinstall
if necessary.
Tank-in-Tank Lid is not properly installed Reinstall lid; refer to page 6.
Tank-in-Tank is not properly seated Tank-in-Tank must be firmly seated
to function. Remove and reseat
Tank-in-Tank.
Tank-in-Tank has picked up the maximum Empty tank and refill; refer to
page 6.
ReadyTools Dial may be at the Set ReadyTools Dial to either FLOOR
wrong setting for cleaning job. CLEANING or TOOLS/PRETREAT.
Poor tool position. Readjust angle; apply more
(Handheld attachments only.) downward pressure.
Thank you for selecting a BISSELL product.
If you should happen to need assistance during assembly or operations, call 1-800-263-2535.
Please do not return this product to the store
1
10
1
2 2
3 3
WARNING:
To reduce the risk of
fire, electric shock
or injury, unplug
appliance from outlet
before servicing.
Troubleshooting
4 4
5 5
1 1
2 2
3 3
4 4
5 5
6 6