Comelit MU 3451 - Manual (Page 3)

3
,;:._-#*"1 ABCÅÄĄÆßČĆ2 DEFÉĘĚ3
GHI4 JKLŁ5 MNOŃÖØÓ6
PQRS7 TUVÜ8 WXYZ9
space 0
EN
CALL USER
_ _ 2
CALL CANC
MARIO ROSSI
CODE: 002
SCROLL CALL
M_
OK
ESC CANC
MARIO ROSSI
CODE: 002
SCROLL CALL
ENTER PASSWORD:
******
OK CANC
On power-up, the device runs a diagnostic test of the connections to
check for correct communication and confi guration.
The message PLEASE WAIT indicates self-testing in progress.
On completion of self-testing, press the key to put the module in
standby.
Calling a user Self-testing
Activating the lock-release relay
by entering the password code
Finding a name in the directory
√ In standby
√ In standby
√ In standby
1. Enter the user code (e.g.: 2).
2. Press
to make the call or to cancel and exit.
1. Press .
2. Enter the password code.
5. Press to make the call or to exit.
1. Press to access the directory search function.
2. Enter the name (full name or just the fi rst letter).
3. Press to start searching.
4. Scroll through the directory using .
or:
1. Scroll through the directory using .
2. Press to make the call or to exit.
Activating the relay with the RFID key
√ In standby
„ Pass the key near the RFID sensor.
KEY ACCEPTED
KEY REJECTED
» The green LEDs light up for a few seconds.
» "KEY ACCEPTED" appears on the display.
» The lock-release contact is opened.
» The red LED fl ashes.
» "WRONG KEY" appears on the display.
3. Press to confi rm or to cancel and exit.
» A confi rmation message will appear on screen when the procedure
is complete.
Press the relevant key repeatedly to enter special characters.
Special characters