Cambridge SoundWorks BassCube 821 Subwooer/ Amplifer System - Manual (Page 12)

12
Speaker Connections
To connect the speaker cables.
The BassCube 821 will accept your choice of speaker
wire up to AWG#16. We recommend at least AWG#18
for runs up to 12 feet, and AWG#16 for longer runs.
Speaker wire is generally marked in some way to help
identify the “+” and “–” conductors at each end.
Sometimes this is done by printing on the jacket, a rib-
bon stripe molded in, or different color wires. Be cer-
tain to maintain the proper polarity at each connection.
Push back the red speaker output tab on the rear
panel “R” speaker output exposing the wire hole.
Fully insert one of the wires into the wire hole and
release the tab.
Repeat the procedure with the adjacent speaker wire
and the black speaker output tab for the Right channel.
Connect the two wires at the other end of that same
speaker cable to the “+” and “–” connections on the
right-hand satellite speaker. This satellite becomes the
Right channel satellite. Use the same wire for “+” at
both ends.
Repeat the preceding process to connect the other
satellite (making it the Left channel satellite).
POWER
120VAC 60Hz
RISK OF FIRE
REPLACE FUSE
AS MARKED
AC Connection and Placement
Make sure the subwoofer Power switch is in the OFF
position (O).
Plug the supplied power cable first into the subwoofer
back panel AC socket. Then connect it to an AC
power socket.
Place the satellites and subwoofer in their preferred
positions, then switch the Power swith to the ON (I)
position.