beautypg.com

Beko DWD857 User Manual

Page 7

background image

7

When deciding on where to install your new

dishwasher, ensure that the position of your

dishwasher makes it easy and quick for you to

place the dishes in the dishwasher and also to

take them out and store away after the

dishwashing is completed.
Avoid placing the dishwasher where the ambient

temperature is likely to fall below. 0 degrees

C. (32° F)
When positioning your appliance, take care not

to damage your flooring, pipes wall coverings

etc. Do not move the appliance by pulling by

the door or handle

Before you insert the plug into the wall socket

make sure that the voltage and the frequency

shown in the rating label corresponds to your

electricity supply.
We recommend that this appliance be

connected to the mains supply via a suitable

switched and fused socket in a readily accessible

position.
Should the mains lead of the appliance become

damaged or need replacing at any time, it must

be replaced by a special purpose made mains

lead which can only be obtained from a Beko

Authorized Service Agent.

If the supply cord or the mains lead is damaged

please do not replace it by your own. The

supply cord or the mains lead must be replaced

by a Beko Authorized Service Agent personnel

or a similarly qualified person.

If the fitted moulded plug is not suitable for

your socket, then the plug should be cut off

and an appropriate plug fitted.

Destroy the old plug, which is cut off as a plug

with a bared cord could cause a shock hazard

if inserted into a socket elsewhere in the house.

The moulded plug on this appliance

incorporates a 13A fuse. Should the fuse need

to be replaced an ASTA approved BS1362 fuse

of the same rating must be used. Do not forget

to refit the fuse cover. In the event of losing

the fuse cover, the plug must not be used until

a replacement fuse cover has been fitted.

Colour of the replacement fuse cover must be

the same colour as that visible on the pin face

of the plug. Fuse covers are available from any

good electrical store.

As the colours of the wires in the mains lead of

this appliance may not correspond with the

coloured markings identifying the terminals on

your plug, proceed as follows:

1 Connect the green - yellow or green (earth)

wire to the terminal in the plug marked ‘E’ or

with the symbol or coloured green and

yellow or green.

2 Connect the blue (neutral) wire to the terminal

in the plug marked ‘N’ or coloured black.

3 Connect the brown (live) wire to the terminal

in the plug marked ‘L’ or coloured red.

With the alternative plugs a 13A fuse must be

fitted either in the plug or adaptor or in the

main fuse box. If in doubt contact a qualified

electrician.

L

Brown or red

N

Blue or

black

Green and yellow

or green