How to use, How to disassemble – Black & Decker JE2001 User Manual
Page 6
10
9
Product may vary slightly from what is illustrated.
1. Fruit and vegetable feeder
2. Food Chute
3. Clear cover
4. Stainless-steel cutter/strainer
5. Pulp separator
6. Continuous flow juice spout
7. Juice container
8. Safety locking latch (on each side)
9. Non-slip rubber feet antidérapante
10. Removable pulp container
11. Off/Low/High (Apagado/Baja/Alta) control
12. Cord storage compartment
How to Use
This appliance is for household use only.
The unit has a motor overheating protection system that automatically shuts off
the motor to protect it from overheating. Wait 5 minutes for unit to cool down.
Unplug the unit then plug again to resume operation.
Important: Before you use it for the first time, disassemble the unit (see How to
Disassemble section), wash all parts as instructed in the CARE AND CLEANiNG
section.
HOW TO ASSEMBLE AND USE
1. Place the pulp separator on the base with the juice spout facing
you
(E).
2. insert the cutter/stainer in the center of the pulp separator. Turn it
left and right a few times until it fits into place
(F).
E
F
How to Disassemble
1. To unlock the locking latches, pull open at the bottom of each
latch to disengage from the groove on the cover
(A).
2. To remove the cover, take out the feeder; grasp the chute and
pull up the cover
(B).
3. To remove the pulp separator, grip the juice spout with one hand
and the back edge of the pulp separator with the other hand.
Pull it up with the cutter/strainer in place
(C).
4. To remove the cutter/strainer, hold the juice spout with one
hand and grasp the cutter/strainer rim with the other hand;
pull it out
(D).
Caution: The cutter/strainer teeth are very sharp. Handle it
carefully.
5. To remove the pulp container, grasp the sides firmly and slide it out.
B
C
D
ALTA
APAGA
DO
BAJA
A
APAGADO
BAJA
ALTA