Barranca Diamond BD7 Trim Saw - Manual (Page 9)

9
BD7
The BD7 will manually cut specimens up to 1-3/16" (30mm) in height and has a 14" (356 mm) x 14"
(356 mm) self-aligning tabletop.
Blade Lubricate
Approximately 1/3 gallon (1.3 liters) of lubricant is required to adequately cover the bottom of a 7-inch
(178 mm) blade. See Figure 5 for proper lubricant level.
The use of petroleum or vegetable based mineral is highly recommended as a lubricant for use with
BD7. However, water soluble cutting fluid additives can be used with water at a 30 to 1 ratio.
NOTICE: Water is not recommended for use with the Saw. The steel arbor shaft can rust. In
addition, poor sawing performance and short blade life can result if water is used.
UNPACKING
The BD7 Trim Saw has been carefully packaged for protection during transit from the factory to your
location. The blade has been factory installed and the arbor nut securely tightened. No assembly is
required.
If any components are missing or damaged, save the packing list and materials and advise Barranca
Diamond and the carrier of any discrepancies.
BD7 SPECIFICATIONS
PRODUCT SPECIFICATION
Motor Soga MR48
Horse Power 1/3
Voltage* 115V/60Hz
Amperage 4.4
Motor RPM 3,300
Blade Arbor 1"
Blade Capacity 7"
Depth of Cut 1-3/16"
Max. Vise Opening 2-3/4"
L x W x H (in)
L x W x H (mm)
17" x 18" x 12"
432 x 457 x 305 mm
Saw Weight 28 lbs.
Part # 168765 (w/Hood & Vise)
Part # 170789 (w/o Hood & Vise)
*220Volt w/Hood & Vise Part # 169780