Autoquip SR4 MANUAL TURNTABLE - Manual (Page 10)

10
LIFT MOUNTING – Operating Above Floor Level
1. Make sure the lift surface is clean and level before starting.
2. Center the turntable base on the lift. Set the turntable platform aside for now.
CAUTION!
When moving the turntable assembly, do not attempt to pick it up by the
turntable platform; it is attached and could be damaged. Pick up the
turntable from under the base frame at a joint ONLY.
3. The base plate of the turntable has pre-drilled holes for attaching the turntable
securely to the lift platform. Mark the holes, drill, and attach with Class 2 (or
higher) hardware. The turntable base may be welded to the lift platform, if
desired (See Figure 4).
4. Install the turntable platform to the turntable base as shown in Figure 5.
WARNING!
The turntable base MUST be attached securely to the lift platform before
operating the turntable.
INSTALLATION INSTRUCTIONS