Anchor CLASSIC SOLID SAFETY POOL COVER GROMMET SETTING - Manual (Page 2)

Grommet Setting Kit
Cutter
Die Bottom
Die Top
Place cutting block under mark. Place cutter over mark
(between stitch lines) and strike with mallet to cut hole.
After hole is cut, place cutting block on top of pool cover.
Place Die Bottom on top of cutting block. Place grommet
on top of Die. Fold pool cover back over on top of grommet.
Grommet will stick up through hole. Place grommet washer
over the grommet, rounded side up.
Cutting block
Insert Die Top into grommet
2
Cutting block
Cutter
1
3
4
Using a mallet, tap
the Die lightly at
fi rst, then increase
strength until grom-
met is set.
5
Mallet
6
Grommet installed
GROMMET SETTING INSTRUCTIONS