Bosch MON170CL - Manual (Page 9)

EN | 9
Bosch Security Systems | 6 July 2005
MON170CL | Instruction Manual | Installation
5.4 Connecting the Y/C (S-video) Signal
to the Monitor
There is one (1) mini-DIN type connector for the
S-video (Y/C) input (see Figure 2 and Figure 3 below).
N NO OT TE E:: Both Y and C inputs are terminated with 75
1
3 4
2
1. GND
2. GND
3. Y-signal IN
4. C-signal IN
5.5 Connecting Audio to the Monitor
There is one (1) set of mini phone jack for the audio
connector (Figure 2 and Photo F).
Photo F
5.6 Connecting the Analog VGA Signal
to the Monitor
There is one (1) 15-pin D-sub connector (Figure 4) for one
analog VGA input. Refer to Figure 2, item B.
Figure 4: Analog VGA Connector
5.7 VESA Standard Mounting Hole (For
Wall-mount Use)
1. Carefully press the cover and remove it from the
stand. (as shown in photo G)
2. Unscrew the three holdings screws hidden under the
high cover before separating the stand from the panel.
(as shown in photo H)
3. The square mounting hole patterns are VESA standard
on 100 mm (3.9 centers, as shown in photo I).
Mount the unit to mounting device using the four
mounting holes on the rear panel.
Photo G
Photo H
Photo I
Figure 3: Y/C Connection Pinout