Aladdin Light Lift ALL300RM-CM-240V - Manual (Page 18)

STEP 38
Tighten fixture coupler set screws using supplied 3/32” Allen wrench. Fixture coupler set screws have
thread lock already applied at factory. See Diagram S.
STEP 39
Apply supplied liquid thread lock to all fittings including fixture coupler and screw collar loop fittings. See
Diagram S.
Never attach the chandelier to the ALL300RM improperly. Failure to secure the fixture coupler set
screws and properly apply thread lock could cause the chandelier to fall, which could cause death,
personal injury, and/or property damage.
STEP 40
Replace canopy and bottom screw collar ring. Confirm top of canopy is just below edge of bottom contact
plate. See Diagram S.
Never allow the chandelier canopy to make contact with the ceiling before the contact plates meet. This
could interfere with the automatic shutoff system and could cause the chandelier to fall, which could
cause death, personal injury, and/or property damage.
Bottom Screw Collar Ring
Canopy
Tighten Set
Screws with
3/32” Allen
Wrench
Top of Canopy
Just Below Edge
of Bottom
Contact Plate
Diagram S