AirLive WT-2000R - Manual (Page 94)

about 8 times, the RESTORE process is completed. However, if LED flashes 2 times, repeat.
2. Restore directly when the router power on
First, push the RESET button about 5 seconds (Status will start flashing about 5 times), remove the finger. The
RESTORE process is completed.
4.How to do recovery mode when the router is abnormal ?
A: Allocate a Static IP Address on your computer as below:
Step1:First, press the reset button and power on the router until Status blinks very ffast.
Step2:Find the Inter Protocol(TCP/IP) Properties from My Network Places and check Properties
of Local Area Network Connection. And click the “General” icon and assign one IP address
which can be from 192.168.1.1 to 192.168.1.253. Here we use the 192.168.1.88 as
the IP address. The Subnet mask must be 255.255.255.0, and the Default gateway must
be 192.168.1.254. Then click “OK” button to complete TCP/IP setup.
Step2: Open the command mode and input “cmd” then check if the router replies to ping
192.168.1.254
AirLive WT-200R User’s Manual 94