AirLive ARM-204 v2 - Manual (Page 13)

Chapter 3: Connecting ADSL2+ Router via
Ethernet and USB
You can connect ADSL2+ router with PC through either Ethernet cable or USB cable. After
connection is established, you can configure the host PC to be a DHCP client. You have to repeat the same
steps for every host PC on your network if you use DHCP function on your router.
3.1 Setup ADSL2+ router via Ethernet Cable
If there is an available LAN card present on your PC, you just simply connect ADSL router and PC
through the Ethernet cable. Once you establish Internet connection, you could browse the Web through the
Ethernet cable.
3.2 Setup ADSL2+ router via USB Cable
You can connect ADSL router with PC via USB cable when there is no LAN card present on your PC.
USB cable acts as another LAN connection in this scenario. Once you establish Internet connection, you
could browse the Web through the USB cable.
USB Device Driver Installation for Windows Vista/XP/2000/ME/98SE
Step 1: Connect ADSL Router and PC with USB cable.
Step 2: Once “Found New Hardware Wizard” window pops out, chooses “Install from a list or specific
location (advanced)”. Click ‘Next’ or “Locate and install driver software” and follow Windows instructions.
(Figure 1: For Windows Vista)
10
AirLive ARM-204 v2 User’s Manual