AIM Sports SKS Muzzle Brakes - Manual (Page 2)

CAUTION
Always check and be certain that the firearm is unloaded
before undertaking any work upon it.
PJS001P & PJS002P INSTRUCTIONS
1. Use a punch and mallet to remove small pin on front sight.
2. Slide muzzle brake on with notch facing up.
3. Line notch up with hole in front sight.
4. Take new front sight pin and put it through the notch in muzzle
brake and the hole in the front sight.
5. Make pin flush with out side of muzzle brake.
PJS003B INSTRUCTIONS
1. Locate the two hex head screws.
2. Remove screws and clamp.
3. Place muzzle brake on end of barrel with the notch facing up.
4. Replace clamp and tighten screws until secure.
PJS001P & PJS002P INSTRUCTIONS
1. Loosen small locking screw (do NOT remove).
2. Slide muzzle brake onto end of barrel with vent holes facing up.
3. Turn muzzle brake into locking position.
4. Tighten locking screw until secure.
FEATURES
• Heat treated, erosion resistant all steel construction
• Black oxide finish
• Reduces barrel climb and recoil
• No gunsmithing required
• Compatible with Chinese and Russian SKS models (PJS001P
and PJS002P only)
• Compatible with all SKS models (PJS003B only)
• Compatible with Romanian, Chinese, and Russian SKS models
(PJS005T only)
SKS MUZZLE BRAKES
PJS001P
SKS Muzzle Brake / Pin-on - Short
CAUTION
Do not over tighten the screws or you may strip the
threaded holes. Stripped holes are NOT covered by warranty.
PJS002P
SKS Muzzle Brake / Pin-on - Long
PJS003B
SKS Muzzle Brake / Bolt-on
PJS005T
SKS Muzzle Brake / Twist-on