Service and maintenance, 10 troubleshooting – Echo 73040 Owners Manual v.2 User Manual
Page 17
Page 13
EZ Trim Mower Owners Manual
Problem
Probable Cause
Suggested Remedies
Broken off or damaged belts
Replace belts
Broken spindle
Repair spindle
Failed bearings
Repair bearings
Cutting string is too weak
Replace with heavier cutting string
(.155)
Growth is too thick or heavy
Reduce trimming area by half or raise
the trimmer head off the ground
Engine not running at full RPM
Speed up engine to full throttle
Cutting string is too weak
Replace with heavier cutting string
(.155)
Drive belts are loose or worn
Replace drive belts
Growth is too thick or heavy
Reduce the size of trimming area in
half or raise the trimmer head off the
ground slightly
Belts too tight
Move spindle hub assembly towards
the rear of the trimmer
Drive belts are loose or worn
Replace drive belts
Worn or damaged pulley
Replace pulley
Gas tank is empty
Fill gas tank
Spark plug wire is disconnected
Connect loose wire to the spark plug
Spark plug is defective
Replace spark plug
Gas line is obstructed (bail
disconnected)
Remove gas line at carburetor and
check for obstruction. Drain gas tank
and refill with fresh gasoline.
Dirty, stale, water-contaminated gas
Drain tank and fill with fresh gasoline
Flooded engine
Put throttle control in run position and
crank engine several times to clear
out excess gas
Dirty or plugged air cleaner or engine
cooling fins
Clean air cleaner or replace. Clean
cooling fins and shroud area of
engine.
Engine brake control open
Replace engine brake control
Pulley not aligned
Align pulleys
Belt not tensioned properly
Tension belt with 70 lbs of force
Spindle bearing failed
Replace bearing
Loose chain
Tighten chain
Worn chain
Replace chain
Worn sprocket
Replace sprocket
Sprocket not aligned
Align drive sprocket and wheel clutch
assembly with washers
Engine won't start or is
hard to start
Drive belt rolling or falling
off of pulleys
Chain Falling off Self
Propelled Model
Cutting strings do not
turn
Cutting is slow or rough
Trimmer requires
excessive power or stalls
Drive belts squealing or
smoking
Service and Maintenance
4.10 TROUBLESHOOTING