Echo LS21160 Owners Manual v.3 - Manual (Page 7)

3 LOG SPLITTER
ENGLISH
SAFETY
WARNING
When splitting large and heavy material it is possible
for the log splitter to tip. Secure the stand before
operating.
Do not step across the log splitter while the engine is 23.
running.
Do not straddle or reach across the splitting area when
24.
operating the machine.
When splitting logs in the vertical position, stablize the
25.
log before engaging the control. Split as follows:
a. Place log on the end plate and turn until it leans
against the beam and is stable.
b. When splitting extra large or uneven logs, the
log must be stablized with wooden shims or split
wood between the log and end plate or ground.
When at all possible, keep log splitter attached to a 26.
towing vehicle. If you are unable to do this, secure
the hitch.
1.5 mAINTENANcE ANd SToRAGE SAFETY
Before inspecting, servicing, storing, or changing 1.
an accessory, shut off the machine and make sure
all moving parts have come to a complete stop.
Disconnect the spark plug.
Replace any missing or unreadable safety decals.
2.
Refer to the safety decal section for part numbers.
Allow machine to cool before storing in an enclosure.
3.
Store the machine out of reach of children and where 4.
fuel vapors will not reach an open flame or spark.
Never store this machine with fuel in the fuel tank
5.
inside a building where fumes may be ignited by an
open flame or spark. Ignition sources can be hot water
and space heaters, furnaces, clothes dryers, stoves,
electric motors, etc.
Drain the fuel and dispose of it in a safe manner for
6.
storage periods of three months or more.
Replace any worn, cut, abraded, flattened or crimped
7.
hydraulic hoses.
Wear proper hand and eye protection when searching
8.
for a hydraulic leak. Instead of using your hands, use
a piece of wood or cardboard as a backstop to identify
a leak.
1.6 ToWING SAFETY
Ensure the log splitter is locked in the horizontal 1.
position before towing.
Extend log splitter ram all the way before towing to
2.
help maintain stability (see picture below).
Connect hitch safety chains. Tighten trailer hitch bolts.
3.
Do not attempt to tow the trailer if the vehicle is not
equipped with a 2” (50 mm) ball.
Inflate tires to manufacturer’s specifications as stated
4.
on the tire sidewall.
Do not tow machine faster than 45 mph (72 kph).
5.
Optimum towing performance can be achieved by 6.
maintaining a horizontal trailer hitch.
Check wheel lug bolts periodically to ensure they are
7.
tight and secure.
Make sure the jack stand and retractable stand are
8.
in the uP position during towing. Place the jack stand
and retractable stand on a level surface and secure
them in the DOWN position before using.
Never allow passengers to ride on the machine.
9.
Shut off fuel supply when towing. 10.
Towing laws may vary in different countries/regions/ 11.
states. It is recommended that you contact your local
motor vehicle department for any special regulations
that pertain to towing and know the laws of any country/
region/state you travel through.
Correct towing configuration with ram extended and stands up