3 filling hydraulic fluid, 4 changing hydraulic oil filter, 5 lubrication – Echo LS21160 Owners Manual v.5 User Manual
Page 17: Important, English
13
LOG SPLITTER
ENGLISH
SERVICE & MAINTENANCE
BEFORE INSPECTINg OR SERVICINg ANy PART OF THIS MACHINE, SHuT OFF POWER SOuRCE,
AND MAKE SuRE All MOVINg PARTS HAVE COME TO A COMPlETE STOP.
WARNING
5.5 LubRIcATIoN
ImPoRTANT
Polyurea and lithium-based greases are not compatible.
Mixing the two grease types may lead to premature
failure.
NoTE
Do not over grease bearings. Overfilling can lead to
excessive heat and/or unseating of the seals. Add
grease slowly and under light pressure. Whenever
possible, rotate bearing slowly while lubricating.
lubricate the machine periodically with a lithium-based
grease. Extreme working conditions will require more
frequent greasing. Check the wheel bearings after the first
20-25 hours of use and repack with grease once a year.
5.3 FILLING HYdRAuLIc FLuId
5.4 cHANGING HYdRAuLIc oIL FILTER
Change the hydraulic oil filter after the first 50 hours of
operation and every 200 hours thereafter.
To change the hydraulic oil filter:
using an oil filter wrench, turn the filter
1.
counterclockwise.
Once the filter becomes loose, turn it out the rest of the
2.
way with your hand.
Properly discard old filter.
3.
lube the rubber seal on the new filter (PN 16922) with
4.
clean hydraulic oil.
Install the filter onto the threaded pipe. Turn with your
5.
hand until the filter is finger tight.
using an oil filter wrench, tighten the filter another ½
6.
turn.
Check hydraulic oil level and fill if necessary.
7.
The hydraulic tank is located in the back of the machine.
Check the fluid level with the dipstick before each use.
Check the fluid on level ground with the jack stand in the
down position. The hydraulic pump requires premium
hydraulic fluids containing high quality rust, oxidation, and
foam inhibitors. These include premium turbine oils, API
CD engine oils per SAE J183, M2C33F or g automatic
transmission fluids meeting Allison C-3 or Caterpillar TO-
2, and certain specialty agricultural tractor fluids.
Do not overfill.
Fill the hydraulic fluid tank with the ram
retracted.