Echo GT-225 - Manual (Page 14)

14 X7722271207
© 03/2013 ECHO Inc.
ASSEMBLY GT-225
Nylon Line Installation
1. Shut engine off. Lay unit on the ground with head assembly
up.
2. Remove old nylon line through center recess of head.
3. Thread new lines through outside holes (A) in housing until
ends meet in center of recess.
Note: Insert cutting line ends to center of head recess to insure
easy removal of used lines.
Front (Loop) Handle
Note: Label shows minimum spacing for front handle location.
Note: Front handle is pre-installed. Re-positioning and
tightening is all that is required.
1. Position front handle (A) in comfortable operating position
and tighten wing nut (B). The cutting attachment should be
5-7.5 cm (2-3 in.) above the ground and as level as possible.
A
MIN
SPACING
A
B