Echo GT-230 - Manual (Page 4)

4
INTERNATIONAL SYMBOLS
SYMBOL
DESCRIPTION/APPLICATION
SYMBOL FORM/
SHAPE
SYMBOL
DESCRIPTION/APPLICATION
SYMBOL FORM/
SHAPE
HOT
SURFACE
SYMBOL
DESCRIPTION/APPLICATION
SYMBOL FORM/
SHAPE
SYMBOL
DESCRIPTION/APPLICATION
SYMBOL FORM/
SHAPE
"WARNING, SEE
OPERATOR'S
MANUAL
WEAR EYES, EARS
AND HEAD
PROTECTION
EMERGENCY STOP
FUEL AND OIL
MIXTURE
FINGER SEVERING
PRIMER
BULB
Ignition
ON/OFF
WEAR HAND AND
FOOT PROTECTION
WARNING
DO NOT EXCEED
10,000 RPM.
BEWARE
- THROWN,
RICOCHET
OBJECTS
EQUIPMENT
WARNING DANGER
• Use only ECHO approved attachments. Serious injury may result
from the use of a non approved attachment combination. Read
and comply with all safety instructions listed in this manual and
safety manual.
• ECHO, INC. will not be responsible for the failure of cutting
devices, attachments or accessories which have not been tested
and approved by ECHO.
Before operation a complete check of the unit must be performed;
• Check unit for loose/missing nuts, bolts and screws. Tighten and/or
replace as needed.
• Inspect fuel lines, tank and area around carburetor for fuel leaks.
DO NOT operate unit if leaks are found.
• Inspect shield for damage and ensure that the cut-off knife issecurely
in place. Replace if either is damaged or missing.
• Check that the cutting attachment is firmly attached and in safe
operating condition.
• Check that front (loop) handle or optional shoulder harness are
adjusted for safe, comfortable operation. See Assembly for proper
adjustment.
• Have repairs done only by an authorized ECHO dealer.
• Do not use any attachment, accessory or replacement part unless it is
recommended in the Operator's manual.