Echo HEDGE TRIMMERS SAFETY MANUAL - Manual (Page 21)

21
Fuel Leaks
After the unit has cooled, pour fuel remaining in the tank
into an approved fuel container. Purge any fuel left in
purge bulb by pressing bulb until it is empty. Pour fuel
removed from purge bulb into an approved fuel container,
and tighten fuel container cap securely.
Tag unit to prevent refueling until leak has been corrected.
Contact your dealer for service.
•
NEVER transport a unit with a fuel leak until all fuel has
been safely drained into an approved fuel container.
•
NEVER continue to wear clothing that has had any fuel
splashed, spilled, or leaked on it - wet clothing down
with water immediately. Wash affected area, and
change into dry clothing as soon as possible.
•
ALWAYS dispose of fuel-soaked rags in a fire-proof
safety container. Air-dry fuel-contaminated clothing
outside, and wash with detergent and water before
rewearing.
•
Never put fuel-contaminated clothing into a clothes
dryer to dry without first washing thoroughly.
If a fuel leak occurs while a unit is being transported in an
enclosed truck or equipment trailer, or while unit is being
stored between uses, safely vent spill area to dissipate
fuel vapor. Do not allow heat, sparks, open flame, smok-
ing materials, or other sources of ignition near spill area.
Follow instructions for draining fuel from tool. Contact
your dealer for service after tagging unit to prevent refuel-
ing until repairs have been made.
Mechanical Problems
Sudden vibration, unusual noise, or poor cutting perfor-
mance may all be indications of a loose or broken part,
improper blade adjustment, or lack of lubrication. Oper-
ating the unit with any of these problems can cause a jam
or other sudden malfunction that could result in an injury.
Stop using the unit, and check it carefully for problems.
Correct all problems before using unit again, or tag it until
it can be repaired by an authorized servicing dealer.
OPERATION