beautypg.com

Assembly, Power head shaft/lower shaft assembly, Support handle installation – Echo PAS-280 User Manual

Page 13: Pas-280 assembly

background image

PAS-280

ASSEMBLY

© 1/2014 ECHO Inc.

X7502312904

13

ASSEMBLY

Power Head Shaft/Lower Shaft Assembly

1. Set Power Head/Shaft Assembly on a level surface.

2. Pull locator pin (A) out, and turn counter-clockwise 1/4 turn

to lock-out position.

3. Remove vinyl cap from attachment drive shaft.

4. Remove cardboard spacer, if necessary.

5. Carefully fit attachment drive shaft assembly into coupler (B)

to decal assembly line (C), making sure that the inner lower
drive shaft engages the square upper drive shaft socket.

Note: Lower bearing housing and head assembly must be in

line with the engine.

6. Rotate locator pin (A) 1/4 turn clockwise to engage lower

shaft hole. Insure locator pin is fully engaged by twisting
lower drive shaft. Locator pin should snap flush in coupler.
Full engagement will prevent further shaft rotation.

7. Secure lower shaft assembly to coupler by tightening

clamping knob (D).

Support Handle Installation

Note: Label shows minimum spacing for support handle

location.

1. Position support handle for comfortable operation and

secure screws.

Parts Required:

PAS Attachment

For more information
scan this QR code.

A

B

D

C

MIN

SPACING