Echo HCA-266 - Manual (Page 9)

HCA-266 SAFETY
X7502026406 9
© 10/2014 ECHO Inc.
Cutting Angle Adjustments
• Only adjust cutting blade angle with unit flat on the ground, with the engine stop switch in the “STOP”
position. Never adjust cutting angle with unit standing upright.
Avoid Contact With Gear Box Assembly During Use
• Gear box assembly becomes hot during use. Avoid contact with
gear box assembly when using unit or making cutting angle
adjustments.
Avoid Hot Surfaces
• Keep exhaust area clear of flammable debris. Avoid contact
during and immediately after operation.
Never perform blade maintenance procedures while engine is running.
Equipment
Use only ECHO attachments. Serious injury may result from the use of a non-approved attachment
combination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or
accessories which have not been tested and approved by ECHO. Read and comply with all safety
instructions listed in this manual and safety manual.
• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.
• Check that the cutting attachment is firmly attached and in safe operating condition. Dull, loose or
damaged blades should not be used.
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings.
•
ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a
complete stop before removing obstructions, clearing debris, or servicing unit.
•
DO NOT start or operate unit unless all guards and protective covers are properly assembled to
unit.
•
NEVER reach into any opening while the engine is running. Moving parts may not be visible
through openings.
Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or
leaks are found, do not use unit, otherwise serious personal injury or property damage may occur.
Have unit repaired by an authorized servicing dealer before using.
For more information
scan this QR code.