beautypg.com

Equipment, Shc-266 safety – Echo SHC-266 User Manual

Page 9

background image

SHC-266

SAFETY

X7502026703

9

© 6/2014 ECHO Inc.

Keep a Solid Stance

• Maintain footing and balance at all times. Do not stand on

slippery, uneven or unstable surfaces. Do not work in odd
positions or on ladders. Do not over reach.

Avoid Hot Surfaces

• During operation, the drive shaft housing and attachment bearing

housing may become very hot, too hot to touch. Avoid contact
during and immediately after operation.

Never perform blade maintenance procedures while engine is running.

Equipment

Use only ECHO attachments. Serious injury may result from the use of a non-approved attachment
combination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or
accessories which have not been tested and approved by ECHO. Read and comply with all safety
instructions listed in this manual and safety manual.

• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.

• Check that the cutting attachment is firmly attached and in safe operating condition. Dull, loose or

damaged blades should not be used.

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings.

ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a
complete stop before removing obstructions, clearing debris, or servicing unit.

DO NOT start or operate unit unless all guards and protective covers are properly assembled to
unit.

NEVER reach into any opening while the engine is running. Moving parts may not be visible
through openings.

Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or
leaks are found, do not use unit, otherwise serious personal injury or property damage may occur.
Have unit repaired by an authorized servicing dealer before using.

For more information

scan this QR code.