beautypg.com

Echo 7812086 Instruction v.2 User Manual

Instructions, Warning

background image

Instruction Sheet

Instructions

SUBJECT: 12" ChIpper Blade
replaCement KItS (pn 73900-00
and 76297-00)

MODELS: all 12" ChIpperS

pn 73901-00

rev. 033009

WARNING

the chipping blades are sharp! Use care when working

on the machine to avoid injury.

WARNING

Before inspecting or servicing any part of this machine,

shut off power source, remove key, disconnect the

battery cables and make sure all moving parts have

come to a complete stop.

BLADE ACCESS

COVER BOLTS

BLADE ACCESS

COVER LOCK PIN

turn off the engine and allow all moving parts to come

1.

to a complete stop.
rotate the discharge chute toward the left side of the

2.

machine.
remove the two 1/2" x 1-1/4" bolts, nuts and washers

3.

securing the blade access cover to the chipper housing

(see below).
lift the engine hood and locate the Blade access Cover

4.

Jack inside the chipper housing next to the hydraulic

fluid reservoir (see below).
turn the wing nut located on the bottom of the jack to

5.

the right and pump the handle.
Secure the cover using the Blade access Cover lock

6.

pin located on the outside of the chipper housing (see

below).
rotate the disk until a chipper blade is accessible.

7.

Secure the disk to prevent movement while removing

8.

the chipping blades.

When closing the rotor cover, make sure the bolts are

securely tightened. If they are not, the safety switch

may respond as though the battery is dead.

NOTE

remove the hardware holding the blade to the disk.

9.

remove and discard blade.
Bolt on the new blade using the new hardware. torque

10.

to 230 ft-lbs (312 nm). repeat for remaining blades.
Check how the blades clear the anvil. all blades

11.

should clear the anvil by 3/16" - 3/8". adjust the anvil

if necessary (see your owner's manual).
to lower the cover, remove the Blade access Cover

12.

lock pin and turn the wing nut to the left to release

the hydraulic pressure.
Secure the blade access cover to the chipper housing

13.

using two 1/2" x 1-14" bolts, nuts and washers.

This manual is related to the following products: