Preparation for use, Cs-400 description – Echo CS-400 User Manual

Page 15

CS-400

DESCRIPTION

X7503251607

5. Clutch - Turns drive sprocket when engine rpm is fast enough to provide the power needed for cutting.

Preparation For Use

Saw chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury
may result.

Note: The machine may be delivered with guide bar, tip guard, and

saw chain separated. Install guide bar, tip guard, and saw
chain as follows.

Tip Guard to Bar Instructions

Tools Needed: Two 11 mm (7/16 in.) Wrenches. For saws with tip
guard P/N 2893201 and Symmetrical or Asymmetrical
Low-Kick type (Double Guard) guide bars.

1. Install bolt (A) in

rear hole (B) of tip guard and through front

hole (C) in guide bar.

2. IMPORTANT: Dimple (D) in tip guard must engage recess (E)

in guide bar.

3. Securely tighten nut (F) and bolt (A).

Guide Bar and Saw Chain Installation/Removal

Note: Align the brake connector (B) of the sprocket guard to the

groove on the side of the brake lever (Front hand guard).

1. Remove air cleaner cover and disconnect spark plug lead.

2. Move the chain brake lever (A) (Front hand guard) fully

rearward to remove or install the sprocket guard (C).

3. Remove sprocket guard nuts (D) and remove sprocket guard

(C).

4. Remove guide bar and saw chain if necessary.

Note: See “Maintenance and Care” section for guide bar/saw chain

maintenance procedures.

For more information

scan this QR code.

For more information
scan this QR code.