Operation cs-400f starting warm engine, Running – Echo CS-400F User Manual

Page 22

X7503253302

OPERATION

CS-400F

Starting Warm Engine

Make sure the bar and chain are free from any obstruction
when starting the chain saw.

1. Move chain brake lever fully forward to lock chain brake

before starting.

2. Confirm there is fuel and chain oil in the tanks.

3. Move ignition switch to “RUN” position.

4. Securely hold the chain saw as shown and pull starter

handle.

5. Choke may be used if necessary, but after first starting

sound, squeeze throttle trigger to release choke and return
engine to idle.

Note: If engine does not start after 5 pulls, use cold start

procedure.

Note: Do not increase engine speed while chain brake is locked.

Severe brake damage will result.

Running

The saw chain should not move at idle, otherwise serious
personal injury may result.

Note: If saw chain moves adjust carburetor according to

“Carburetor Adjustment” instructions in this manual, or see
your dealer.

1. After engine starts, allow it to return to idle and warm up

before using.

2. Move chain brake lever fully rearward to unlock chain brake.

3. Squeeze throttle trigger (B) gradually and increase engine

speed.

4. The chain starts running when the engine reaches clutch

engagement speed (see technical data page).

5. Confirm proper acceleration and lubrication of chain and bar.

6. Do not run the engine at high speed unnecessarily.

Chain brake

Unlock Chain brake