Echo CS-355T - Manual (Page 27)

CS-355T MAINTENANCE
© 09/2013 ECHO Inc.
X7503320105 27
MAINTENANCE
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts
have come to a complete stop before removing obstructions, clearing debris, or servicing unit.
Allow unit to cool before performing service. Wear gloves to protect hands from sharp edges and
hot surfaces.
Your ECHO unit is designed to provide many hours of trouble free service. Regular scheduled maintenance
will help your unit achieve that goal. If you are unsure or are not equipped with the necessary tools, you may
want to take your unit to an ECHO Service Dealer for maintenance. To help you decide whether you want to
DO-IT-YOURSELF or have the ECHO Dealer do it, each maintenance task has been graded. If the task is
not listed, see your ECHO Dealer for repairs.
Skill Levels
Level 1 = Easy to do. Common tools may be required.
Level 2 = Moderate difficulty. Some specialized tools may be required.
ECHO offers REPOWER TM Maintenance Kits and Parts to make your maintenance job easier.
Maintenance Intervals
MAINTENANCE PROCEDURE LETTER CODES: I = INSPECT, R = REPLACE, C = CLEAN

IMPORTANT NOTE - Time intervals shown are maximum. Actual use and your experience will determine the frequency of required
maintenance.
MAINTENANCE PROCEDURE NOTES:

(1) Low evaporative fuel tanks DO NOT require regular maintenance to maintain emission integrity.
* Replacement is recommended based on the finding of damage or wear during inspection.
COMPONENT/SYSTEM
MAINTENANCE
PROCEDURE
REQ’D
SKILL
LEVEL
DAILY OR
BEFORE
USE
EVERY
REFUEL
3
MONTHS
OR 90
HOURS
YEARLY
600
HOURS
Air Filter Inspect/Clean 1 I / C * R *
Automatic Oiler Inspect/Adjust 1 I
Oil Filter Inspect/Replace 1 I I / C *
Fuel System Inspect/Replace 1 I (1) * I (1) *
Fuel Filter Inspect/Replace 1 I * I / R *
Fuel Cap Gasket Replace 1 I * R *
Guide Bar & Sprocket Nose Inspect/Clean/Lubricate 1 I / C * I
Saw Chain Inspect/Sharpen/Replace/
Tensioning
2 I *
Sprocket Inspect/Replace 2 I *
Spark Plug Inspect/Clean 1 I / C / R *
Cooling System Inspect/Clean 2 I / C
Muffler Spark Arrestor Inspect/Clean/Replace 2 I / C / R *
Cylinder Exhaust Port Inspect/Clean/Decarbon 2 I / C
Recoil Starter Rope Inspect/Clean 1 I / C *
Screws/Nuts/Bolts Inspect/Tighten/Replace 1 I *