beautypg.com

Srm-280u assembly, U-handle installation, Throttle linkage and ignition leads – Echo SRM-280U Serial S75012010176 - S75012999999 User Manual

Page 16

background image

16

X7502310808

© 02/2014 ECHO Inc.

SRM-280U

ASSEMBLY

4. Insert Cotter Pin (C) in hole in PTO shaft, and bend pin legs

around shaft counterclockwise to retain 10 mm nut.

Never reuse a cotter pin - install a new cotter pin each time a blade
is installed or replaced.

5. Remove locking tool (G).

U-Handle Installation

1. Install upper U-Handle and bracket on lower bracket with

one (1) 8mm x 55mm bolt (N) and (1) large circular washer.
Do not tighten bolt securely until final adjustments are
completed.

2. Loosen upper (2) U-handle clamp screws (O), and position

U-handle as shown.

3. Lightly tighten 8mm bolt (N) and clamp screws (O) to hold

U-handle in position until final adjustments are completed.

4. Route throttle linkage and ignition lead assembly along shaft and clip as shown.

5. Install throttle linkage cable into fan cover clip (C), if

required.

Throttle Linkage and Ignition Leads

1. Close choke and remove air filter cover.

2. Place inner throttle cable in large hole of carburetor swivel

(A).

3. Loosen nuts (B) and place threaded end of throttle linkage

in bracket slot. Finger tighten nuts (B).

4. Check throttle for freedom of movement and that wide open

throttle / low idle extremes are adjusted properly. If
adjustment cannot be achieved with adjusting nuts (B),
consult with your Echo Dealer for correct adjustment
procedure. Tighten nuts (B).

Parts Required:

U-Handle, Clamp w/screws, 8 mm x 55 mm hex
bolt, 8 mm flat washer

A

G

M

E

D

C

20

N

O

C

A

B

This manual is related to the following products: