Step. 1, Step. 2, Step. 3 – IOGear GUH227 User Manual

Page 4: Step. 4

Connect the power adapter to the power supply and the other end to the USB 2.0 port

Step. 1

5. Pictorial Introduction

6. Hardware Installation of the 7-Port USB 2.0 Hub

1. USB 2.0 Ports (7 downstream ports)

2. USB 2.0 (1 upstream port)

3. Power port

4. The IOGEAR Logo, a mark of quality

Note: Before you begin, please make sure that your computer has been turned off.

Step. 2

• Plug the Hi-Speed USB 2.0 Cable (Type B connector) into the USB 2.0 upstream port

• Plug the Hi-Speed USB 2.0 Cable (Type A connector) into your computer’s USB 2.0 or USB 1.1 port.

Step. 3

Turn on your computer

Step. 4

Once your computer has finished booting up, a series of messages will let you know that the USB 2.0 Hub
has been recognized and the Hub is successfully installed.
Note: If you are using non-high-speed USB 1.1 port a series of warning will prompt to remind you that a non-
high speed port has been detected. In that case just close the warnings windows and continue.