IOGear GME228BW6 - Manual (Page 8)

8
Installation (Windows XP-Widcomm BTW 5.1.0.2700)
In the example below, the Bluetooth software
used was WIDCOMM BTW 5.1.0.2700
Make sure your computer is Bluetooth- 1.
enabled and that it supports the Bluetooth
HID profi le.
Turn ON the mouse.
2.
Open your Bluetooth software (My 3.
Bluetooth Places, in our example)
Press and hold the Connect button located
4.
under the mouse for approximately fi ve (5)
seconds; this will set the mouse in discovery
mode.
Start the search for Bluetooth devices
5.
(Search for devices in range)
The IOGEAR Bluetooth 6. ® mouse should be
listed as shown in the image. If the mouse is
not detected, repeat step 4 and search for
your Bluetooth
® mouse again.