BURY CC 9068 USER Manual - Manual (Page 25)

25
Settings
Settings
In this menu point, you can configure the HFCK through five further
submenus. These are Bluetooth, Voice dial, Audio, Display and
Device.
Bluetooth
In the telephones menu item, in the telephone list, the telephones are
listed which have previously successfully been connected with the ap-
plication via
Bluetooth . The list is able to include a maximum of ten
telephones. If an additional telephone is connected the oldest entry is
deleted. The car and clef symbols after the telephone name display
show the
Bluetooth profile with which the corresponding mobile phone
was connected.
With the „CLEAR LIST“ command it is possible to delete the full tele-
phone list. You are able to assign an individual „PIN CODE“ for the
Bluetooth connection in the next menu item. Your own code must be at
least four figures long – with a maximum of eight being allowed.
Select a telephone from the list. Here, every telephone can be con-
nected, disconnected, deleted or set as the standard. The standard
telephone will always be sought as the first telephone if the auto-
matic connection has been activated and it is always at the top of the
list of telephones. In addition to this, with an activated Multipoint func-
tion, this is always the primary telephone. If the mobile phone also
supports music play back via AD2P, this
Bluetooth profile can also be
connected or disconnected in addition to the hands-free mode. This
means it is possible to play back music from a telephone but to take
phone calls via the HFCK at the same time. With incoming calls or the
activation of the voice control, the play back of music is automatically
interrupted.
Auto connect on
Bluetooth
Phone list
Clear list
Pin code
Telephone