Bosch SGV45E03UC - Manual (Page 11)

11
Rinse Agent Dispenser
open the rinse agent dispenser by lifting the tab with your thumb as shown in
figure 17.
NOTE: the dishwasher indicates low rinse agent by showing the symbol in the
countdown display.
add liquid rinse agent to the dispenser as shown in figure 18 until the rinse agent reservoir
is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.
NOTE: After filling the rinse agent dispenser, the indicator light will go out in a few
minutes after the dishwasher door is shut (select models only).
Operating the Dishwasher
always make sure your dishware is dishwasher safe. refer to the Dishware Materials
section of this manual for guidance.
Wash Cycles
Power Scrub Plus
Cleans items having baked-on or hard dried-on food soils. these items may require soaking
or hand scouring.
Auto
takes the guesswork out of cycle selection. sensors adujst cycle length, temperature and
water changes based on the soil load. this cycle is appropriate for mixed loads.
Regular
thoroughly cleans large loads having loosely attached normal soiling.
Quick Wash
for lightly soiled items with easy to remove food soils.
Wash Cycle Options
Half Load
in the power scrub plus, regular and auto Wash cycles you can reduce the energy and
water consumption when washing small, lightly soiled loads that fill approximately half of
the dishwasher’s capacity. to activate, select the Half load button in addition to the power
scrub plus, regular or auto Wash cycle button.
Extra Dry Heat
With this option you can raise the temperature of the rinse water and increase the drying
time which will result in improved drying.
to activate:
· press and hold the left “Cancel Drain” button, then press and hold the on/off button.
· When the leD display shows a “00” or a “01” release both buttons.
· to enable the additional Drying Heat, press the left “Cancel Drain” button until the leD
display shows a “01”.
· to disable the additional Drying Heat, press the left “Cancel Drain” button until the leD
display shows a “00”.
· press the on/off button to save the setting.