JLG 26MRT ANSI Operator Manual - Manual (Page 35)

SECTION 5 - OPTIONAL EQUIPMENT
3120790 – JLG Sizzor – 5-1
SECTION 5. OPTIONAL EQUIPMENT
5.1 HORN
The warning horn is located on the frame of the machine,
and is controlled by a push button switch on the platform
control console. The warning horn permits the operator to
warn jobsite personnel when the machine is operating in
the area.
5.2 TRAVEL ALARM
The travel alarm horn produces an audible warning when
the machine is in the travel (drive) mode. It will function in
forward or reverse to warn jobsite personnel the machine
is traveling.
5.3 MOTION ALARM
The motion alarm horn produces an audible warning
when the machine is in the travel (drive) or lift mode. It will
function in forward, reverse, lift up or lift down to warn job-
site personnel the machine is traveling or lifting.
5.4 DESCENT ALARM
The descent alarm produces an audible warning when
platform lift control is placed in the lift down position. The
alarm warns personnel in the jobsite area to avoid the siz-
zor arms.
5.5 TILT ALARM
Senses when the machine is out of level in any direction
approximately 5° and illuminates a warning light at the
platform control station and sounds the machine’s horn,
signaling the operator.
5.6 110 VOLT RECEPTACLE
The 110 Volt dual receptacle is mounted on the platform
kick rail. The receptacle is connected to a plug on the
machine frame which can be connected to a ground
receptacle.
5.7 PLATFORM WORK LIGHTS
The two platform work lights are installed on the platform
rails, one at the front and one at the rear, to provide addi-
tional lighting for the operator. Each light is equipped with
an on-off switch.
5.8 ROTATING BEACON
An amber rotating beacon is installed on the machine
frame. When the machine power is turned on, the light is
activated and provides a visual warning to the machine’s
operation.
5.9 FOLD-DOWN HAND RAILS
The fold-down handrails enable the operator to take the
machine into areas where platform height may pose a
clearance problem. The fold-down hand rails give the
operator an additional 14 inches (36 cm) of clearance.
5.10 DUAL FUEL SYSTEM
This system permits the gasoline engine to run on either
gasoline or LP gas. Included are the LP supply tank and
the hoses and valves necessary to permit the engine to be
switched between gasoline operation and LP gas opera-
tion.
5.11 PIPE RACKS
The machine may be equipped with bolt-on pipe racks,
suitable for carrying long sections of pipe, conduit, or tub-
ing. The racks bolt to the right top rail of the platform and
contain a tie down belt to secure the load being carried.