JLG 680S Operator Manual - Manual (Page 85)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121233 – JLG Lift – 6-1
SECTION 6. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6.1 INTRODUCTION
This section of the manual provides additional necessary
information to the operator for proper operation and mainte-
nance of this machine.
The maintenance portion of this section is intended as infor-
mation to assist the machine operator to perform daily main-
tenance tasks only, and does not replace the more thorough
Preventive Maintenance and Inspection Schedule included
in the Service and Maintenance Manual.
Other Publications Available:
Service and Maintenance Manual ............................ 3121234
Illustrated Parts Manual ............................................ 3121235
6.2 OPERATING SPECIFICATIONS
Table 6-1. Operating Specifications
Maximum Work Load (Capacity)
Unrestricted:
Restricted
500 lb (230 kg)
Refer to Capacity Decals on
machine for restricted platform
capacities
Maximum Travel Grade (Gradeability)*
2WD
4WD
30%
45%
Maximum Travel Grade (Side Slope)* 5°
Maximum Vertical Platform Height: 68 ft. (20.7 m)
Maximum Horizontal Platform Reach 59 ft. (17.9 m)
Turning Radius (outside) 22 ft. 6 in. (6.8 m)
Turning Radius (inside) 12 ft. (3.6 m)
Maximum Drive Speed: 3.5 mph (1.5 m/s)
Max. Hydraulic System Pressure 4500 psi (310 Bar)
Maximum Wind Speed 28 mph (12.5 m/s)
Maximum Manual Force 400 N
Electrical System Voltage 12 Volts