Blaupunkt HEIDELBERG RCM 126 - Manual (Page 8)

33
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
When this function has been activated,
“RM” shows on the display panel.
The radio is played back during fast
tape run.
B
Press to eject the tape.
C 1, 2, 3, 4, 5, 6 - preset buttons
You can store six stations on each me-
mory bank (I, II and “T”).
To store a station: Press button dur-
ing radio operation and hold down until
the radio resumes play after the mu-
ting (confirmed by a beep tone).
To recall a station: Select the desired
memory bank and press the corre-
sponding preset button.
Extra function preset buttons
To store and recall a PTY programme
type.
On FM, you can store and recall one
programme type on/from each preset
button when PTY is active (“PTY”
lights up in the display).
D Cassette loading slot
Insert the tape with side A or 1 facing
up, the open side showing to the right.
E Tape side selector
Press this button to switch over to the
other side during tape operation. The
display shows “TR 1” or “TR 2”.
F B
Dolby B NR*
Press this button to play back a tape
which has been recorded with Dolby-B
noise reduction. When this button is
pressed, „B“ lights up in the display.
* Noise Reduction system manufactured under li-
cense from Dolby Laboratories Licensing Cor-
poration. „Dolby“ and the double-D symbol are
trademarks of Dolby Laboratories Licensing Cor-
poration.
G LD
Loudness - When listening at a low
level, the Loudness function creates a
more natural sound by boosting the
low frequency range.
LD on/off: Press the button.
When the Loudness function is active,
“LD” will light up in the display.
See chapter “DSC programming” for
more information.
? SRC (source)
You can switch between the different
audio sources radio, tape, and CDC/
AUX (if activated).
@ DIS
Radio operation
When pressing the DIS button, the fre-
quency will be displayed for approxi-
mately four seconds.
Tape operation
When pressing the DIS button, the sta-
tion name/frequency will be displayed
for approximately four seconds.
Changer operation (optional)
To switch the display mode and select
between name, time (playback time)
and number (disc number):
•
Press DIS briefly.
A RM (Radio Monitor)
Press this button to listen to the radio
while fast forwarding or rewinding the
tape.
To switch RM on/off: Press RM.
Heidelbg RCM126 gb® 07.06.2002, 12:46 Uhr 33