BenQ MP610 - Manual (Page 29)

Operation 23
4. Check the new password.
i. Pressing Auto completes the procedure.
ii. Press Up
5 to try again.
iii. Press Down 6 to cancel the set-up and return to the on-screen menu.
Adjusting the height
The projector is equipped with 1 quick-release adjuster foot and 1 rear adjuster foot. These
adjusters change the image height and projection angle. To adjust the projector:
1. Lift the projector up and press the
adjuster button to release the
adjuster. The adjuster will drop
into position and be locked.
Do not look into the lens while the lamp is
on. The strong light from the lamp may
cause damage to your eyes.
2. Screw the rear adjuster foot to fine
tune the horizontal angle.
To retract the foot, hold up the projector while pressing the front adjuster button, then
slowly lower the projector. Screw the rear adjuster foot in a reverse direction.
If the screen and the projector are not perpendicular to each other, the projected image
becomes vertically trapezoidal. To correct this situation, adjust the value of Keystone in the
Picture menu, on the projector control panel, or on the remote control.
Auto-adjusting the image
In some cases, you may need to optimize the picture
quality. To do this, press Auto on the control panel of the
projector or on the remote control. Within 3 seconds,
the built-in Intelligent Auto Adjustment function will
re-adjust the values of Frequency and Clock to provide
the best picture quality.
The current source information will be displayed at the
bottom right of the screen for 3 seconds.
The screen will be blank while Auto is functioning.
Fine-tuning the image size and clarity
1. Adjust the projected image to the size
that you need using the zoom ring. 2. Then sharpen the image by rotating
the focus ring.