JLG 2658E3 ANSI Operator Manual - Manual (Page 18)

SECTION 2 - MACHINE PREPARATION AND INSPECTION
2-6 – JLG Sizzor – 3120761
26. Motor/Pump Unit - Properly secured; no visible
damage; no evidence of hydraulic leakage.
27. Hydraulic Fliter - No visible damage; properly
secured; no evidence of leakage
28. Tilt Switch - Properly secured; no loose or miss-
ing parts; no visible damage; no loose or broken
wires.
29. Hydraulic Reservoir - No visible damage; no
loose or missing parts; no evidence of leakage.
Recommended hydraulic fluid level on side of
tank. Breather cap secure and working.
30. Powered Deck Extension Cylinder (If Equipped) -
Properly secured; no visible damage; no loose or
missing parts; no evidence of leakage.
31. Steer/Drive Wheel and Tire Assembly, Right Front
- Properly secured; no loose or missing lug nuts;
no visible damage; check drive hoses.
32. Drive Motor, Right Front - Properly secured;no
visible damage; no evidence of leakage.
33. Safety Prop - Properly secured;no loose or miss-
ing parts; no visible damage.
34. Handrail Installation - All railings securely
attached; no visible damage;no missing parts;
chain improper working order. If equipped,
access gate properly secured and in good work-
ing order.
35. Platform Assembly - No loose or missing parts;no
visible damage; platform deck extension oper-
ates properly.
36. Scissor Arms and Sliding Wear Pads - Properly
secured;no visible damage; no loose or missing
parts.
37. (Not Shown on Illustration) Valves, Valve Fittings,
Hosing and Tubing - Properly secured; no loose
or missing parts; no visible damage;no evidence
of leakage.
Figure 2-2. Daily Walk-Around Inspection Points (Sheet 3 of 3)