JLG M4069 Service Manual - Manual (Page 35)

SECTION 3 - CHASSIS & SCISSOR ARMS
3121824 – JLG Lift – 3-7
2. To charge the batteries, connect the charger to a
230 volt source with a 15 amp minimum capacity.
3. The charge cycle is complete when the 100% LED is
lit. Any other reading indicates the charge cycle is
not complete.
4. The Charger will shut off automatically when the bat-
teries are fully charged.
Depleted batteries will take approximately 17 hours to
charge.
Charging Sequence of Remote LED Card
1. Plug in charger.
2. All three LED’s (light emitting diode) flash three
times.
3. In sequence.
a. Green LED flashes once.
b. Yellow LED flashes once.
c. Red LED flashes once.
4. All Three LED flash three times.
5. Yellow LED comes on indicates charger is charging.
6. Yellow LED will stay on until fully charged and green
LED will illuminate.
7. If Red LED remains on, this indicates a fault.
Battery Charger (Delta-Q)
The battery charger is located on a tray behind the hinged
JLG cover at the front of the machine, or on the sliding
engine tray on the (M) model machines.
Figure 3-5. Remote LED Card
Figure 3-6. Battery Charger Location
(M model shown)
1. AC Voltage - Input Cable
2. Charger Interlock Cable 3. DC Power Cable to Batteries
4. LED Indicator Cable
Figure 3-7. Battery Charger
1
2
3
4