Controls and functions, External control panel, External control panel" on – BenQ MP620 User Manual
Page 15
Introduction
9
Controls and functions
External control panel
1.
Power (Refer to
and
for more
information.)
Turns the projector on or off.
2.
Blank (Refer to
for more information.)
Used to hide the screen image. You can press any key on the control panel to bring the
image back.
3.
Mode (Refer to
for more information.)
Depending upon which input signal is selected, there are several picture setup options
available.
When a wireless module is installed and the Wireless Connection menu is displayed,
press this button to change among LAN, IEEE 802.11 a, and IEEE 802.11 b/g. (The
wireless module is available through BenQ retailers.)
4.
Source (Refer to
"Switching input signal" on page 29
for more information.)
Sequentially selects the input signal RGB, Component Video,
S-Video, or
Video.
5.
"Auto-adjusting the image" on page 27
for more information.)
Automatically determines the best picture timings for the displayed image.
When a wireless module is installed, the Wireless Connection menu is displayed and
the IEEE 802.11 a is selected, press this button to search for a reliable channel. (The
wireless module is available through BenQ retailers.)
6.
Lamp indicator light (Refer to
for more information.)
Indicates the status of the lamp. Lights up or flashes when the lamp has developed a
problem.
7.
Temperature warning light (Refer to
for more information.)
Lights up red if the projector’s temperature becomes too high.
1
2
9
8
7
12
6
5
10
4
11
3
13
14
I
I