JLG 450AJ Operator Manual User Manual
Page 29
SECTION 2 - PREPARATION AND INSPECTION
3120868
– JLG Lift –
2-13
17
Air Filter - Ford
Replaceable
Element
N/A
N/A
X
Or as indicated by condition indicator
18
Air Filter - Deutz
Replaceable
Element
N/A
N/A
X
Or as indicated by condition indicator
19
Air Filter - Isuzu
Replaceable
Element
N/A
N/A
X
Or as indicated by condition indicator
NOTES:
KEY TO LUBRICANTS
Lubrication intervals are based on machine operation under normal conditions. For machines used in multi shift operations and/or exposed to hostile envi-
ronments or conditions, lubrication frequencies must be increased accordingly.
EO
EPGL
HO
MPG
OGL
Engine Oil
Extreme Pressure Gear Lube
Hydraulic Fluid (Mobil DTE-11M)
Multi-Purpose Grease
Open Gear Lubricant - Mobiltac 375 or
equivalent
* If necessary install grease fittings into worm gear housing and grease bearings.
DO NOT OVERGREASE BEARINGS. OVERGREASING BEARINGS WILL RESULT IN
BLOWING OUTER SEAL IN HOUSING.
**When changing oil in the Deutz oil cooled engine, drain both the crankcase and the cooler. When refilling it is acceptable to overfill crankcase (10.5 L),
capacity of both crankcase and cooler combined). Start engine, allow the engine to run until the thermostat opens (approximately 105 degrees C) cooler will
fill up within minutes; shut down and wait for approximately two minutes. Check oil level, fill oil to max marking on dipstick.
Table 2-1. Lubrication Chart
Components
Number/Type
Lube Points
Capacity
Lube
Interval
Hours
Comments
3
Months
150 hrs
6
Months
300 hrs
1 Year
600 hrs
2 Years
1200 hrs
Updated 11-2-99