Daily walk-around inspection points - sheet 2 -8 – JLG 120-SXJ ANSI Operator Manual User Manual
Page 24

SECTION 2 - PREPARATION AND INSPECTION
2-8
– JLG Lift –
3121104
25.
Cowling and Latches, Right Side - All cowling and
latches in working condition, properly secured, no
loose or missing part.
26.
Turntable Bearing and Pinion - No loose or missing
hardware; no visible damage, evidence of proper
lubrication. No evidence of loose bolts or looseness
between bearing and structure.
27.
Engine Air Filter - No loose or missing parts, no vis-
ible damage, element clean.
28.
Battery - Proper electrolyte levels; cables tight, no
visible damage or corrosion.
29.
Frame - No visible damage, no loose or missing
hardware (top and underside).
30.
Drive Hub, Left Rear - No visible damage, no evi-
dence of leakage.
31.
Wheel/Tire Assembly, Left Rear - Properly secured,
no loose or missing lug nuts, no visible damage.
32.
Drive Motor and Brake, Left Rear - No visible dam-
age, no evidence of leakage.
33.
Boom Sections - No visible damage; wear pads
secure. All cylinders - rod end shafts and barrel-end
shafts properly secured.
34.
Rotator and Motor - Properly secured, no visible
damage, no evidence of leakage.
35.
Platform Pivot and Slave Cylinder Attach Pins -
Properly secured; evidence of proper lubrication
where applicable.
Figure 2-5. Daily Walk-Around Inspection Points - Sheet 2